collapse

Author Topic: Hybrid valve and TPA311x  (Read 594 times)

jfetter

  • Regular
  • **
  • Posts: 45
  • Chip Points: 19
    • View Profile
Hybrid valve and TPA311x
« on: November 15, 2018, 07:52:42 PM »
Two years have tested others and this one sounds the best.
 I built it point to point but now doing a board.
The tone tilt I think beats all others. Shown here in hifi mode but easy to add scoop.
Uses 12AU7 and $3.00 D class module.

Schematic attached. The fx loop is not fully tested.
Cheers



jfetter

  • Regular
  • **
  • Posts: 45
  • Chip Points: 19
    • View Profile
Re: Hybrid valve and TPA311x
« Reply #1 on: September 13, 2019, 03:29:50 PM »
A reliable pcb pot (ie Beckman ) cost quite a lot. So I put a servo-buffer opamp and configured as a ' super triode' . It took a long time to get it right...
This plot is using a sa5532 with 6sn7 in feedback loop.

It's raw right now in fact going to a lower gain tube but the plot shows 1khz signal , 2 khz dominant harmonic , 4th etc.
Third and fifth very low.


 

* User Controls

 
 
Welcome, Guest. Please login or register.
Did you miss your activation email?

* Recent Posts

Z-MATCHER 100W IMPEDANCE MATCHER by Loudthud
[September 16, 2019, 04:42:44 PM]


Hybrid valve and TPA311x by jfetter
[September 13, 2019, 03:29:50 PM]


Marshall 5010 Needs Help by Jazz P Bass
[September 13, 2019, 12:12:27 AM]


Do you need a low pass filter in your amp when you already have the eq? by slimjohnny
[September 11, 2019, 06:01:57 AM]


Gallien Kruger GT200 by mandu
[September 10, 2019, 06:31:10 AM]

* Sponsors