How to provide + and - to an opamp

[saturated]

Meanwhile in another rabbit hole

I began to wonder if the diode network in the crate schematic was equivalent to the oft seen traditional "diamond" shaped bridge rectifier

Ok so time to draw each side by side and make a comparison

My conclusion is that yes they are the same

You cannot view this attachment.

So I wonder why Crate drew it like that

But I am very glad that they did draw it like that because it was easier for me to make heads or tails out of it 

[Loudthud]

So I wonder why Crate drew it like that

Most schematic programs won't allow you to rotate a symbol by 45 degrees. You can only rotate things in 90 degree increments. If you are using discrete diodes, you are usually stuck with things going left, right, up or down, unless someone created a diode symbol with the diode going diagonally. Most engineers are too lazy or don't know how to create special symbols.

If you have a symbol for a bridge rectifier, it can be drawn with diagonal diodes. But it's a complete symbol, not individual diodes. If you want individual diodes, you have to use the symbol for individual diodes or when PCBs come back, there will be the footprint for a bridge rectifier.

[Kaz Kylheku]

Most schematic programs won't allow you to rotate a symbol by 45 degrees.

Even so, if you prefer the diamond configuration, you can approximate it like this: