Realistic MPA-100

[g1]

The cap has the 4 as a multiplier, not as a digit.  So 33 with 4 zeroes, in pF.
For the transistor sub, power and current & Hfe look ok but I don't think the Vceo of the TTC015B is sufficient.  I would look for the TTC004B.

[saturated]

Yes sir thanks also I think I learned 1H means 50 v DC 

[saturated]

Ok
Got my transistors in yesterday so today didn't have a lot of time but hey onward we go

Anyhow wife gave me too much coffee so I had some hella jitters trying to get this in

Also I verified pinout etc

You cannot view this attachment.

And the ugly truth

Oh yeah that nut that was glued to the board and fell off added to the entertainment

You cannot view this attachment.

I did not have tons of confidence in this install so I checked for continuity but fingers crossed apparently no solder bridges

So now just waiting on my capaci-TATERS   

[saturated]

Too much fun

Just had a cow looking at the collector which appears to be touching the heatsink 

Anyhow I did some more continuity tests and I think it's ok but yeah gonna have to pay attention to stuff like that

You cannot view this attachment.


EDIT:  note to self.  Next time you need to bend the legs 90 degrees approximate the horizontal distance needed then find a nice firm sharp 90 degree edge to use as a die
Because it also messes up trying to solder when legs are coming through the hole at an angle SMH

EDIT 2: Maybe instead of nice sharp 90 degree edge I should have said nice CRISP edge.  Like when I used to be in Alberta and when I got cold ❄️🥶 the locals would say "She's getting CRISP" 

[Jazz P Bass]

That 'heatsink' looks to me to be a ceramic pad (for heatsinking purposes).
It should be nonconductive.