Welcome, Guest. Please login or register.

February 27, 2021, 01:49:09 PM

Login with username, password and session length

Recent Posts

 

Author Topic: Fender M-80 Chorus Bias/Avalanche  (Read 72 times)

ilyaa

  • Elite
  • ****
  • Posts: 316
  • Chip Points: 9
    • View Profile
Fender M-80 Chorus Bias/Avalanche
« on: February 23, 2021, 02:10:40 AM »
hey!

got one of these fuzzy carpet amps on the bench -

R155 and Q12 were blown - had -40 VDC on the left output (yowza!)

i replaced R155, Q12 and Q13, and then did the bias mod for good measure (swapped out R127, 129,154 and 156 with 2K resistors) -

the left side had some funky looking electrolytics so i replaced those, too, as well as Q10 and Q11 (just being thorough!)

now: amp turns on without blowing up, BUT if i measure bias across R165 or R166 i see it starts out okay (around 25 mV) and then starts to creep up, with no sign of stopping. i turn the amp off when it gets above 60 mV because i can tell itll keep going until kaboom.

any thoughts what might be the issue? the so-called avalanche diodes (the BYV 26Ds) measure OK but i have a feeling they are not, in fact, OK. however, i am not that familiar with this bias circuit so i am not sure best way to proceed -

thoughts/advice? thank you!

ilya

Jazz P Bass

  • Elite
  • ****
  • Posts: 264
  • Chip Points: 21
    • View Profile
Re: Fender M-80 Chorus Bias/Avalanche
« Reply #1 on: February 23, 2021, 11:39:19 AM »
Well you do have a working amp to compare voltage readings to.
First off, is R 165 cement resistor still good?

ilyaa

  • Elite
  • ****
  • Posts: 316
  • Chip Points: 9
    • View Profile
Re: Fender M-80 Chorus Bias/Avalanche
« Reply #2 on: February 23, 2021, 12:35:48 PM »
yeah the power resistors are all good -

all voltages read pretty much exactly the same both sides until the bias starts to crawl up