Welcome, Guest. Please login or register.

September 18, 2020, 10:19:26 AM

Login with username, password and session length

Recent Posts

 

Author Topic: Blackstar HT5 noisy Clean channel  (Read 426 times)

Psabin8951

  • Regular
  • **
  • Posts: 32
  • Chip Points: 0
    • View Profile
Blackstar HT5 noisy Clean channel
« on: August 15, 2020, 09:51:48 AM »
I have an early (non reverb) Blackstar HT5 here which has a noisy clean channel which occasionally has volume drop but mainly has a crackle and hiss that appears after about 10 mins of being on.
Both valves have been replaced with new matched ones and all connections have been cleaned, checked and resoldered to eliminate them.
Any thoughts what it could be?
At initial switch on it sounds great.

Jazz P Bass

  • Elite
  • ****
  • Posts: 215
  • Chip Points: 18
    • View Profile
Re: Blackstar HT5 noisy Clean channel
« Reply #1 on: August 16, 2020, 01:19:15 PM »
I have attached the input circuit diagram.
The signal branches off of IC2A to the Clean and the Crunch channel.
Either of those is selected by jfets. (Clean/ Fet1: Crunch/ Fet2)
You will need to track down where in the Clean circuit the signal is failing.

« Last Edit: August 17, 2020, 11:51:11 AM by Jazz P Bass »