Author Topic: National GA920P Help  (Read 107 times)


  • Chipper
  • *
  • Posts: 2
  • Chip Points: 0
    • View Profile
National GA920P Help
« on: November 06, 2019, 08:21:36 PM »
Hi all,

If I need to replace the transformer on this little amp (National GA920P), can anyone tell me what I would need?  This particular unit was purchased in Germany, so it's wired for 220V.  I need 120V 60Hz.

Thanks to everyone!


  • Legendary
  • ******
  • Posts: 1860
  • Chip Points: 193
    • View Profile
Re: National GA920P Help
« Reply #1 on: November 06, 2019, 11:10:51 PM »
There is a thread about this model right on this forum.

The power supply is a simple single voltage.  Look at your power transformer.  Are there any unused wires coming from it?  Or are the wires that connect with the mains cord doubled?   If so, you MIGHT have a dual voltage transformer.  I tend to doubt it, but looking is free.

Looking at the thread, further down is a real schematic, it appears you need a transformer that produces  26-0-26 volts AC.  SLightly odd values, so 24-0-24 would work just fine and be easier to find.  That is same as 48vCT  (Center Tapped)


* User Controls

Welcome, Guest. Please login or register.
Did you miss your activation email?

* Recent Posts

Ibanez TSA30 - buzzing by theaterguy
[November 15, 2019, 02:24:52 PM]

Schematic sites for different brands of amps by Jazz P Bass
[November 14, 2019, 11:48:19 AM]

Info on Sunn Stinger 100 amp by Diablo_IV
[November 13, 2019, 12:38:27 PM]

Intermittent loud crackle from Fender Deluxe 112 Plus by traxcontrols
[November 09, 2019, 01:23:37 PM]

So you need a preamp - here are your options by flester
[November 07, 2019, 05:03:55 PM]

* Sponsors