collapse

Author Topic: Question about choke on power amp  (Read 629 times)

Agung Kurniawan

  • Regular
  • **
  • Posts: 10
  • Chip Points: 0
    • View Profile
Question about choke on power amp
« on: January 27, 2017, 06:34:33 PM »
In SS power amp, is that any bad affect if I ignore the choke that come before the speaker?

Loudthud

  • Elite
  • ****
  • Posts: 208
  • Chip Points: 33
    • View Profile
Re: Question about choke on power amp
« Reply #1 on: February 07, 2017, 10:07:29 PM »
Speaking in general terms, that inductor isolates any capacitive load from the amp. If the power amp has high open loop gain or marginal stability, (like most chip amps) a capacitive load might cause the amp to oscillate at an ultrasonic frequency. This usually causes the amp to self destruct in short order. Most amps have a Zobel across the output, a series RC network of something like 0.1uF and 10 Ohms. An ultrasonic oscillation usually causes the 10 Ohm resistor to go up in smoke just before the fuse blows

You might get lucky without the inductor, or you might end up with a smoldering mess.

 

* User Controls

 
 
Welcome, Guest. Please login or register.
Did you miss your activation email?

* Recent Posts

Fender Mustang II v.2 by phatt
[Today at 06:08:35 AM]


signal tracing by Crich
[December 07, 2019, 07:43:20 PM]


Eight Audio Kit TDA7294 and TDA2050 from India by Enzo
[December 07, 2019, 05:25:56 PM]


The Dangers of Speaker Impedance Mismatching by Enzo
[December 05, 2019, 11:44:14 AM]


Gallien Kruger GT200 by gbono
[December 04, 2019, 02:54:12 PM]

* Sponsors