collapse

Author Topic: Peavey Rage 158 - any mod to fit delay after dirty channel?  (Read 483 times)

lpbr

  • Chipper
  • *
  • Posts: 1
  • Chip Points: 0
    • View Profile
Peavey Rage 158 - any mod to fit delay after dirty channel?
« on: April 26, 2018, 11:50:40 AM »
Hi! I am new in forum so I am not sure if here is the correct place for this post.

Past year I had a financial issues and had to sell all of my gear — three guitars (LP, strat and 175) and a Vox Valvetronix Amp. Long story short I am back to the business and slowly trying to buy some stuff back. Currently I am using a Peavey Rage 158 "Transtube" small amp and regardless its size I found it better than I supposed it would. I really like it.

As I am still money tight I cannot move too much and so I am playing with what I have. Surprisingly I am not mad about using the dirty channel of the amp that is satisfactory for my needs. Now I am looking forward to acquire a delay pedal but am anticipating the problem of plug it into the chain BEFORE the distortion.

My question is if there is a known — and preferably easy — mod that I can make in order to fit my delay AFTER the dirty channel and BEFORE the amp section.

Thanks!

 :tu:

Jazz P Bass

  • Elite
  • ****
  • Posts: 157
  • Chip Points: 13
    • View Profile
Re: Peavey Rage 158 - any mod to fit delay after dirty channel?
« Reply #1 on: April 27, 2018, 12:58:25 PM »
There is a way but not an easy one.

You would have to refit the CD input jack as a Send jack.
Plus a Return jack will have to be installed with a normally closed contact so the signal will pass without a pedal installed.

That and you will have to cut a copper trace between R21 & R22 (100K pad resistors for the Cd input).
« Last Edit: April 27, 2018, 04:08:27 PM by Jazz P Bass »

 

* User Controls

 
 
Welcome, Guest. Please login or register.
Did you miss your activation email?

* Recent Posts

Thoughts on the difference in sound between tubes and solid state by jfetter
[October 15, 2019, 07:59:26 AM]


I want to ask a question by Jmatt
[October 11, 2019, 10:47:17 PM]


Does A500 mean 500 ohms or 500k ohm by slimjohnny
[October 11, 2019, 07:11:19 PM]


Using a JC120 as preamp for electric bass - dummy speaker load? by vin97
[October 10, 2019, 01:34:12 PM]


Marlboro PA-50 schematic by globe_02
[October 10, 2019, 04:01:33 AM]

* Sponsors