collapse

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - charlescazaly

Pages: [1]
1
El Cheapo Chinese amp has Gain and volume as well as 3 pot equalizer. It has a push switch to select overdrive or normal. The Volume operates OK when overdrive off. The Volume is a B50K Pot.
Plays sweetly when not overdriven. Clear highs and lows.
When I select overdrive, there is no tapered increase as I turn the gain up. It goes straight to muddy distortion, with less and less clarity as the gain is increased, just more fuzz.
It has Led clipping and the leds light up when overdrive is selected.The Gain Pot is a C100K.
There are 2, 8 pin pre-amp and an amp ic,s. (Can't read op-amps Id).
What I want is more control of gain with a taper from a light beginning to full.
Use it for Electric Acoustic and a Les Paul. No heavy dark stuff, (Ideally, my full on would be around half of normally used overdrive).
Got it as a freebee, almost new. Prepared to tinker. Nice little amp for practice.
Should I be looking at reducing the 25 volts into the pre-amp? (how should I do that)?
Looking for a solution. (and where it should be in the circuit).

Pages: [1]

* User Controls

 
 
Welcome, Guest. Please login or register.
Did you miss your activation email?

* Recent Posts

Fender Mustang II v.2 by phatt
[Today at 06:08:35 AM]


signal tracing by Crich
[December 07, 2019, 07:43:20 PM]


Eight Audio Kit TDA7294 and TDA2050 from India by Enzo
[December 07, 2019, 05:25:56 PM]


The Dangers of Speaker Impedance Mismatching by Enzo
[December 05, 2019, 11:44:14 AM]


Gallien Kruger GT200 by gbono
[December 04, 2019, 02:54:12 PM]

* Sponsors