Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - jon_bondy

Pages: [1]
Preamps and Effects / Re: implementing presets
« on: May 05, 2019, 08:53:46 PM »
@Jazz P Bass:

What do you mean by "it will take a lot more than simple potentiometer changes to get useful presets"?  Can you give me a few examples?

Preamps and Effects / Re: implementing presets
« on: May 02, 2019, 10:13:42 AM »
Hi, Phil.  Thanks for your comments.

I found these

Seems that one can now setup a circuit board that usually uses a pot, and replace the pots with these circuits.  Should allow fairly straightforward presets.

I'm just playing around with this project.   And it could well evolve.


Preamps and Effects / implementing presets
« on: May 01, 2019, 04:26:45 PM »
I'm designing an amplifier based on the Orange Crush series.  The only problem I have with that amp is that there are only two presets (clean and dirty) and the tone controls are shared between the channels.  I want perhaps 5 or 10 presets, each of which uses a different set of values for the various pots.  I could use a huge switch and switch in a bank of pots, but that seems both unreliable and difficult to implement.

Has anyone on this board attempted to implement presets?  What approach did you take?

Pages: [1]

* User Controls

Welcome, Guest. Please login or register.
Did you miss your activation email?

* Recent Posts

Fuse or resistor? by Diablo_IV
[Today at 06:04:34 PM]

Peavy Rage 158 no sound after 1-5 mins by g1
[Today at 04:24:53 PM]

Fender Acoustasonic Jr. Squeal by g1
[June 15, 2019, 01:20:58 PM]

Unicord Stage 65b Output Transistors by joecool85
[June 13, 2019, 12:45:09 PM]

ENGL Fireball E625 Head white noise issue by alessandro_gfdp
[June 01, 2019, 03:10:45 AM]

* Sponsors