collapse

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jon_bondy

Pages: [1]
1
Preamps and Effects / Re: implementing presets
« on: June 22, 2019, 03:18:07 PM »
The amp design is taking shape, and it is likely to be very controversial.  I would appreciate feedback.

The basic idea is to take an Orange schematic, replace the pots with digital pots, and add an Arduino to allow control of the digital pots.  The Arduino would read the pot settings for each preset from a text file present on an SD card.  WiFi or bluetooth connectivity would also be implemented on the board, but I would not want to have to write an Android app for just one amp.  There would be (say) 7 buttons to select one of 7 presets, plus a pot for reverb intensity, a pot for master volume, a pot for amount of lead boost, and a push button to enable/disable lead boost.  Very few controls at all, and none of them related to a preset (although I suppose I could put the lead boost pot into the presets).  All of the configuring would be done ahead of time by editing the text file and copying it onto the SD card in the amp.  Provision for a foot board would also be made (preset selects, master volume, lead boost).

I have no idea how much I would like this level of increased flexibility coupled with increased inflexibility.  That is, this would be an experiment.

Any reactions?

2
Preamps and Effects / Re: implementing presets
« on: May 05, 2019, 08:53:46 PM »
@Jazz P Bass:

What do you mean by "it will take a lot more than simple potentiometer changes to get useful presets"?  Can you give me a few examples?

3
Preamps and Effects / Re: implementing presets
« on: May 02, 2019, 10:13:42 AM »
Hi, Phil.  Thanks for your comments.

I found these

https://www.analog.com/media/en/technical-documentation/data-sheets/AD5228.pdf

https://www.analog.com/en/parametricsearch/10982

Seems that one can now setup a circuit board that usually uses a pot, and replace the pots with these circuits.  Should allow fairly straightforward presets.

I'm just playing around with this project.   And it could well evolve.

:)

4
Preamps and Effects / implementing presets
« on: May 01, 2019, 04:26:45 PM »
I'm designing an amplifier based on the Orange Crush series.  The only problem I have with that amp is that there are only two presets (clean and dirty) and the tone controls are shared between the channels.  I want perhaps 5 or 10 presets, each of which uses a different set of values for the various pots.  I could use a huge switch and switch in a bank of pots, but that seems both unreliable and difficult to implement.

Has anyone on this board attempted to implement presets?  What approach did you take?

Pages: [1]

* User Controls

 
 
Welcome, Guest. Please login or register.
Did you miss your activation email?

* Recent Posts

Z-MATCHER 100W IMPEDANCE MATCHER by Loudthud
[September 16, 2019, 04:42:44 PM]


Hybrid valve and TPA311x by jfetter
[September 13, 2019, 03:29:50 PM]


Marshall 5010 Needs Help by Jazz P Bass
[September 13, 2019, 12:12:27 AM]


Do you need a low pass filter in your amp when you already have the eq? by slimjohnny
[September 11, 2019, 06:01:57 AM]


Gallien Kruger GT200 by mandu
[September 10, 2019, 06:31:10 AM]

* Sponsors