Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - plen

Pages: [1] 2
1
Schematics and Layouts / Re: peavey musician series 400series foot switch
« on: January 08, 2021, 12:32:31 PM »
is the photo of the din socket the back where you solder to.

2
Schematics and Layouts / Re: peavey musician series 400series foot switch
« on: January 05, 2021, 08:32:41 PM »
i just seen this for sale add for the same amp. it has a foot switch. it is the foot switch Jazz P Bass posted. it is different from the schematics posted. on the schematics it is selector combiner distortion reverb tremolo. on the foot switch it is selector combiner reverb tremolo effects.

3
Schematics and Layouts / Re: peavey musician series 400series foot switch
« on: January 05, 2021, 04:07:54 PM »
g1 it is this one. i put an extra switch in it and wired it the same as the layout post. a few of the switches seem to turn things off and on. i dont know if is wired right for the amp.

4
Schematics and Layouts / Re: peavey musician series 400series foot switch
« on: January 04, 2021, 10:38:48 PM »
g1  that is the one.

5
Schematics and Layouts / Re: peavey musician series 400series foot switch
« on: January 03, 2021, 01:30:27 PM »
Jazz P Bass my amp has an extra bit at the right it has 2 knobs and says master. one of the knobs is reverb.

6
Schematics and Layouts / Re: peavey musician series 400series foot switch
« on: January 03, 2021, 07:25:06 AM »
Jazz P Bass my amp does not have tremolo. it has fuzz. if i wire the foot switch the same as the layout you posted will fuzz replace the tremolo.

thanks peter.

7
Schematics and Layouts / Re: peavey musician series 400series foot switch
« on: January 02, 2021, 08:15:08 AM »
i just bought a peavey remote foot switch it has 4 foot switches. it is different from the one for my amp. i also bought a 6 pin din socket to try to rewire it because the one on it has seven pins and no center pin.

8
Schematics and Layouts / Re: peavey musician series 400series foot switch
« on: December 14, 2020, 11:14:31 AM »
thanks Jazz P Bass. i will order 4 spst and 1 spdt latching switches.

9
Schematics and Layouts / Re: peavey musician series 400series foot switch
« on: December 13, 2020, 10:11:56 PM »
are the switches latching or non latching. are they spdt or dpdt.

10
Schematics and Layouts / Re: peavey musician series 400series foot switch
« on: December 13, 2020, 07:10:12 AM »
thanks Jazz P Bass for the reply. the foot switch in that schmatic is for seven pin. i need one for a six pin.

11
Schematics and Layouts / peavey musician series 400series foot switch
« on: December 12, 2020, 09:36:15 PM »
i am looking for a schematic or layout for a peavey musician series 400 series foot switch. any place i can find one or buy one. it is a six pin din cable.

thanks.

12
Amplifier Discussion / Re: peavey musician series 400
« on: December 07, 2020, 04:43:26 PM »
does reverb work using the reverb knob or do you need a foot pedal.

13
Amplifier Discussion / Re: peavey musician series 400
« on: December 03, 2020, 09:12:11 PM »
i changed the four lay down transistors three has heat sinks. are they the power transistors. i also changed the four large diodes. the amp works now. i cant get reverb now. when i got the amp and it worked for half an hour reverb was working. thanks everyone for your help.

14
Amplifier Discussion / Re: peavey musician series 400
« on: November 20, 2020, 09:04:19 PM »
thanks enzo for the reply. i have read a lot of the resistors caps and transistors in the amp. so far 2 1n 4003 diodes are bad and two of the four lay down transistors. i have 1n4005 diodes i will put in. i cant see any of the transistors for sale. is there substitutes for them. there was also a orange disc capacitor not soldered. i will test the rest tomorrow.

15
Amplifier Discussion / Re: peavey musician series 400
« on: November 18, 2020, 05:58:56 PM »
i have not done anything with the amp till today. i checked all the power transistors and hfe is 20  8  20  17  22  21  10  18  i will change 8hfe and the 10hfe ones. are the other ones alright.  thanks.

Pages: [1] 2