Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - Diablo_IV

Pages: [1]
Amplifier Discussion / Fuse or resistor?
« on: June 18, 2019, 04:21:33 AM »
I am restoring an old Randall RG50-112 amp.  When I opened the chassis I saw this component in the picture.  It was mounted vertically on the pcb board with one of the leads either clipped intentionally or blown.  I am trying to figure out if this is a simple fuse or a thermistor or a resistor fuse.  Anyone recognize one of these?  No ohmage and no connectivity reading.

Tubes and Hybrids / 12ax7
« on: July 17, 2015, 06:30:35 AM »
I am going to attempt to build my first guitar amp.  I have a transformer whos output is 24.5V RMS.  Would this be enough juice to bias a 12ax7 for the preamp stage?  I think all of the tube preamp schematics ive seen use like 400 volts to power the 12ax7 in the preamp.  Could I use a 12ax7 in a preamp with only 25 volts for a psu?  If it is possible what would be any negatives. 

Pages: [1]

* User Controls

Welcome, Guest. Please login or register.
Did you miss your activation email?

* Recent Posts

Laney VC30 Output Transformer by phatt
[Today at 12:03:26 AM]

signal tracing by g1
[December 10, 2019, 02:26:30 PM]

Eight Audio Kit TDA7294 and TDA2050 from India by laikairawk
[December 10, 2019, 01:57:45 AM]

The Dangers of Speaker Impedance Mismatching by Enzo
[December 10, 2019, 01:15:39 AM]

Fender Mustang II v.2 by Enzo
[December 08, 2019, 04:46:37 PM]

* Sponsors