Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Topics - noobiePT

#1
Tubes and Hybrids / adding extra gain stages
March 20, 2008, 04:23:42 PM
Hi, im going to build an amp, and well, i want to use it without any pedals, kinda a amp to carry around, but the original schematic doesnt include a gain pot, possible due to few gain stages, it has just 2 gainstages in the preamp.
so what im thinking is to add an extra tube, so adding 2 more gainstages and between the two put a pot to control the gain.
now my doubt is, can i "just" add like that? or i have to see if, i dont know, the transformers will suporte the extra efford or something...
thanks  ;)
#2
Amplifier Discussion / doubt about headphone out
March 07, 2008, 05:58:02 AM
Hey, i've build a ruby amp some time ago, but now i wanted to used it too drive some headphones. my doubt is if i connected "directly" the ruby to some headphones would i "kill" the speaker?? do i have to in some way soften the signal? i wanted to control also the distortion so the connection would be made after the chip... dont know if im making any sense..  :D
thanks all
#3
Amplifier Discussion / doubt about effect loops
March 02, 2008, 09:42:14 AM
hello all! i have some doubts about where to place the effect loop in an amplifier. the only thing i know is that the signal circuit should be away from the power, but where exatly should i put the effect loop? right next to the input jack? a bit far away, after the eq. pots?
many thanks
#4
Hello all, i have a pcb layout from a schematic that i done in the diy layout creator, and when i was to print it, using the option render PnP, the image it creates its too big! how do i put it to "real" size??
thanks ;)