Quote from: teemuk on March 21, 2008, 11:15:24 AM
The comments I read concerning this amplifier state that it is indeed used by connecting a coord from the external speaker output of the master amp to the input of the amp. Sounds odd and risky, I know. If this is done with a tube amp it should be made sure that a plug in the external speaker jack does not disconnect the tube amp's own low-impedance speaker load. Anyway, that advice is based on hearsay I don't know how accurate the information is. Back then stuff like "line level" outputs was not that common either. Thus I would try it with line level signals first (from the "line out" jack or something similar) and only if the gain doesn't seem to be sufficient I would try the speaker output trick.
so i want to use a cord from the line out from the vox to the input on the gibson??
edit: i just tryed it, sounds beautiful. i get no sound out of the vox though....so bacially its just using the gibson as a cab that it doesnt power??? so i dont have to worry about blowing my vox. is it acting like a preamp?
