Does anyone have any info on the CFH mod for the Randal 80/100?
I think it's supposed to eliminate a lot of the volume drop caused by pulling the treble knob out which introduces the diode clippers.
anyone?

Hello, this is a great forum I recently found, and I have some questions for y'all....

First of all, I have a Randall RG-80 112sc combo w/ an 8ohm speaker and an additional 8 ohm speaker out.
Amp is rated:
80w @ 8 ohms
100w @ 4 ohms

Now, I'd like to run the combo into my 4x12 5150 cabinet.

The 4x12 has been rewired from 16 ohms to 4 ohms

The combo has two 8 ohm speaker jacks

Question:
Can I run my combo safely into the single 4 ohm load by simply first unplugging the combo's internal speaker?
If no, then how can I run this setup?


Next question......
Can anyone provide info about the channel cloning mod for these amps?
(turning the Green channel into an additional RED channel)
How to? Who offers it? etc.

Thanks for your help!
sixgunner