Hello All,
My Steel King has suddenly developed this symptom when playing through it: buzzy distortion, lower volume. I don't know if this has anything to do with it, but I had the wrong power adapter hooked up to my volume pedal when I turned the amp on.
When I opened it up, I noticed that one of the resistors looked burned (although it measured fine). It is R119 in the first sheet of the schematic http://www.fender.com/support/amp_schematics/pdfs/Steel_King.pdf (R119 is located at A4)
I replaced the resistor with the same value, but the distortion was still there.
Could someone suggest likely culprits? The speaker, cables, guitar are not the problem. Any help greatly appreciated.
Dan
My Steel King has suddenly developed this symptom when playing through it: buzzy distortion, lower volume. I don't know if this has anything to do with it, but I had the wrong power adapter hooked up to my volume pedal when I turned the amp on.
When I opened it up, I noticed that one of the resistors looked burned (although it measured fine). It is R119 in the first sheet of the schematic http://www.fender.com/support/amp_schematics/pdfs/Steel_King.pdf (R119 is located at A4)
I replaced the resistor with the same value, but the distortion was still there.
Could someone suggest likely culprits? The speaker, cables, guitar are not the problem. Any help greatly appreciated.
Dan