I did reinstall the toothed collar it must not been in contact with the chassis any more.  I soldered that toothed collar to the chassis and all is well...

Thank you all for your help... got it all back together.  For some odd reason I had to ground the new jack to the chassis to stop the buzzing but now it's beyer than new...
Thank you all again...

Ok so after looking and looking im pretty sure that it is the 4 pin fender jack.  I ordered one so we shall see. 
I drew some lines on this picture of what I think you are saying needs to be done. 
Feedback is appreciated...

Ok I have pulled it all apart and here is the actual pin configuration in pic 1.   The jack itself has some rattle going on so I want to replace it.  Does this look any more common?

Second pic the contact on the circuit board by my finger does appear a little messed up.  Is there enough there to solder to?  or what is the fix for that?
Thanks again

This is of the six soldier points on the board... it is the six in the top left corner...
thank you...  I assume it is broken in side as the circuit board is still in tact.  The amp fell forward with the cord in it and fell right on the cord.  now all I have is a loud buzz even when nothing is plugged in.
Thank you so much for your help.

I damaged the 1/4" input jack on my hartke hydrive 210c bass combo amp.
I have searched all day for a replacement with no luck.
Any suggestions would be so very helpful.

Thank you...