i (think i) elaborated briefly earlier in the thread, but my posts are convoluted: in the TDA2030 schematic i'd originally used, the 100uF caps were dotted, as if to imply they were "optional", plus they weren't in the vero layout and another one i found on the web, therefore i omitted them but had considered putting them back in.
so is the proximity to the chip required for reasons similar to how i'd decouple, say, an LFO in a different application? or is there a different principle at work here? trying to learn as much as i can as i go
will work on a new layout tonight and hopefully start work over the next coupla days. after much paranoid quintuple-checking of the LM1875 datasheet schematic, ofc.
cheers
so is the proximity to the chip required for reasons similar to how i'd decouple, say, an LFO in a different application? or is there a different principle at work here? trying to learn as much as i can as i go
will work on a new layout tonight and hopefully start work over the next coupla days. after much paranoid quintuple-checking of the LM1875 datasheet schematic, ofc.
cheers