Solid State Guitar Amp Forum | DIY Guitar Amplifiers
Solid State Amplifiers => The Newcomer's Forum => Topic started by: saturated on May 21, 2025, 11:53:28 PM
I was beating my head against the wall 🧱
I was to make this circuit
IMG_20250521_224439347.jpg
So I was trying to set VCE to 12V and couldn't do it.
I started checking stuff finally disconnected the base and could do it
IMG_20250521_224354893 (1).jpg
Reconnect the base and back to zero (no matter how variable R2 is turned.
IMG_20250521_224409681.jpg
It took me a while :grr :lmao: :dbtu:
It looks like the 2 trimmers are set up opposite each other, but that should just mean you would have to turn them in different directions, I think it should still work.
Yes sir thanks
My apologies I should have said look for the misprint on the schematic I'm sorry you had to look through the spaghetti 🍝 birds nest on the breadboard. xP
Now I'm still not out of the woods because I'm gonna have to figure out and explain why that happened when I had it like that :grr