Solid State Guitar Amp Forum | DIY Guitar Amplifiers
Solid State Amplifiers => Amplifier Discussion => Topic started by: rz76 on March 10, 2016, 09:10:19 PM
Hi all. This is my first post.
I have an amp by the Rock Co., a Petros I. The reverb.delay line was originally glued up above and the glue finally let go. Two of the connecting wires broke off at the circuit board end -- but I'm at a loss to see where.
Anyone have or know where I can get a schematic? Thanks, RZ
P.S. I have checked your Schematics section.