Text only | Text with Images

Solid State Guitar Amp Forum | DIY Guitar Amplifiers

Solid State Amplifiers => Amplifier Discussion => Topic started by: khryss98 on September 19, 2010, 06:10:36 AM

Title: HELP!! NEED A SCHEMATIC FOR MY OLD SAMICK BA80 BASS AMP.
Post by: khryss98 on September 19, 2010, 06:10:36 AM
hello guys, Just found recently that my old bass amp SAMICK BA80 in the stock room. when I tried it, a smoke came out from the box., open it and a power amp IC got burned maybe the dust brought it to short circuit. try to replace it but couldn't read the Label of the IC., Please Help I need a Schematic to repair it. Thank you in advance.  ;D
Title: Re: HELP!! NEED A SCHEMATIC FOR MY OLD SAMICK BA80 BASS AMP.
Post by: J M Fahey on September 19, 2010, 10:26:34 PM
Post a couple sharp well iluminated pictures, measure supply voltages, state what's written on the back of the amp, etc.
If it is very old and uses a semi-custom Sanken or some other OEM chip you may be out of luck.
Samick is a *good* factory and works well, their products are famous under other OEM trademarks.
At worst it's a good base for some project.
Title: Re: HELP!! NEED A SCHEMATIC FOR MY OLD SAMICK BA80 BASS AMP.
Post by: Enzo on September 19, 2010, 11:27:18 PM
And contact Samick and ask them if they can provide the schematic.
Text only | Text with Images