Solid State Guitar Amp Forum | DIY Guitar Amplifiers
Solid State Amplifiers => The Newcomer's Forum => Topic started by: Zappacat on December 11, 2009, 01:51:16 AM
I recently purchased an oscilloscope(PROTEK 6502 20Mhz-2 channel trace Oscilloscope) that didn't have any probes. By mistake I bought a probe (Avex 10x oscilloscope probe 100Mhz) that has a higher frequency rating. Can I use the probe with this scope? What are the implications of using these two together or will they even work at all?
Thanks!
Hi zappacat.
It *should* work as a charm, it's higher quality than the original part.
Think of it like this: You meant to buy 5% resistors and got 1% resistors by mistake.
All it means is your probe can be used in more demanding places than your scope.