Welcome to Solid State Guitar Amp Forum | DIY Guitar Amplifiers. Please login or sign up.

March 28, 2024, 03:27:32 PM

Login with username, password and session length

Recent Posts

 

National GA920P Help

Started by mwdavis, November 06, 2019, 08:21:36 PM

Previous topic - Next topic

mwdavis

Hi all,

If I need to replace the transformer on this little amp (National GA920P), can anyone tell me what I would need?  This particular unit was purchased in Germany, so it's wired for 220V.  I need 120V 60Hz.

Thanks to everyone!

Enzo

There is a thread about this model right on this forum.

https://www.ssguitar.com/index.php?topic=3850.0

The power supply is a simple single voltage.  Look at your power transformer.  Are there any unused wires coming from it?  Or are the wires that connect with the mains cord doubled?   If so, you MIGHT have a dual voltage transformer.  I tend to doubt it, but looking is free.

Looking at the thread, further down is a real schematic, it appears you need a transformer that produces  26-0-26 volts AC.  SLightly odd values, so 24-0-24 would work just fine and be easier to find.  That is same as 48vCT  (Center Tapped)