Thanks Enzo on spkr, I got it

I plan to build the light bulb limiter, test the spkr, 
hook up a spkr, and then fire it up. If light goes out I'll
let it sit and bake for awhile before turning up any knobs.

Thanks

It wants 4 ohm load so I assume that the internal (on board)
Spkr is 4 ohm. So if the spkr on board is 4 ohm I can just use that
And be done.

Whats the deal with the talk about the internal speaker.
They say if the internal spkr is connected don't plug in àn external.
Spkr else could fry power transiators.

My main concern was whether or not I should fire it up without doing any tests on components so that I don't burn somehing out.

If I can fire it up I will just attach a spkr plug and pliug it in back Either jack I assume is ok.

Will it operate without or should I operate it without the reverb pan hooked up ?  I dont know but maybe its ok to operate without but you just wont get any reverb.

I just obtained a free Peavy 130 Special beside the road however they must of trashed it for a reason.
I'd like to get it operating. I fix my own Deluxe Reverb tube amp but havn't tried to fix a solid state amp.
I was an electronics tech by trade way back and know transisitor theory, NPN,PNP sensitive to tests etc.
I checked out the components and all appear good, ie no burned resistors etc.
The speaker looks good but its disconnected but not sure where to connect it.
I also assume it had a reverb tank but its missing (four pins in center of psb I believe)
Where do I start

Thanks in advance

Gary from Western Mass