Most meters have a separate input to connect one of the probes to when you measure current. There is almost always an internal fuse that will blow if you forget to move the probe back to the Voltage jack when measuring Voltage.
30% off all Honey Amp kits, check it out at https://store.ssguitar.com !
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Show posts MenuQuote from: saturated on May 12, 2023, 09:45:08 AMback to the light switch question...they are all single pole switches right?I don't want to give away the answer, and I applaud your determination to figure it out for yourself, so I'll give you this: At the Home Improvement store where they sell what you need to do the trick, they call the switches you need to do the common two switch circuit a "three way switch" and the one you need to add for the three switch circuit a "four way switch". Once installed and covered up with a face plate, the switches look and feel like the normal On-Off switches you see and use every day. (These names apply in the USA, not sure about other countries.)
Quote from: FleshOnGear on April 07, 2023, 05:24:32 PMWhy does the preamp appear to be so mismatched to the sensitivity of the power amp? Why wasn't the amp designed with lower voltage rails, so it would clip before reaching that amount of power? Why is the current protection set to clamp so high? Is the amp actually capable of safely providing much more output than the rated 100W into 4 ohms? How do I figure out how hard I can drive the amp before it burns out? What am I missing that makes this design make sense?