Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Topics - geertjacobs

#1
Found a Fender Deluxe 85 that needed some care: crackle in pots, sound was cutting out from time to time and it needed a good cleaning.

First cleaned the amp, then used contact spray to clean the pots.
I tilted the amp after applying the contact spray, so the contact spray was kept away (somewhat) from the lubricated pot shaft. That seems to have helped in preserving the nice "feeling" of the pot while still cleaning it. FWIW.

The amp was then sounding ok, but after a few minutes of playing the amp still cut out regularly when strumming hard. Web searches indicated that the pcb mounted jacks in these amps can be problematic. So I found some reasonably priced replacements (prices seem to vary quite a bit). The old jacks have a transparent top plate (nuts were quite rusty). The new jacks look cheaper (one big plastic part) but work better.
After replacing all 6 jacks the cutting out is gone.

The clean channel is quite usable, the distortion channel needs quite some tweaking. The parallel channel feature seems rare, haven't played around with it yet.
Nice amp for the price.




#2
Hello, first post on this forum!

My post is about repair of an ss amp. I'm not sure if this forum is intended for repair questions, so please let me know if it isn't.

A friend has a Perfomer 1000 that was in a bad state: a bad repair of power caps that had desoldered themselves at some time.
I thought I could do a better job and took the amp home.
In the mean time i have replaced the power amp transistors and the elco's and it played so I thought I had fixed it.

However after 2 minute of playing, the amp starts to motorboat no matter at what volume ( so it seems like a power amp or power supply issue). Also the power amp gets extremely hot, even when not playing loud.
I tried using cold spray on the active components to see if the defect was temperature related, but I couldn't find a component that reacted on the cold spray.

Any ideas where to look?
Anybody seen something similar before?