yeah, you need a 14v-0-14v ac power supply, or 28vac center tapped. so yep, close enough.
i'm putting 6600uf caps in mine, they seem to run better with them. 2200 is ok, but quite a bit of ripple if ya run these hard. i tend to dime stuff, ....well.... i generally run the tone stack around 6, and the volume and gain dimed, anyways
however i marked them big caps is how they are on the board, but there's parts that just are omitted here and there.. not even mentioned on the board.
rob says i got that gain connection wrong, so i gotta check again WITH my beeper... but i think he's confusing the way the connection goes, cuz what you have now seems to match the drawing i had started and the board.
just to be sure, tho, i'm gonna beep it after dinner.
the jacks are like, identical to these:
https://www.taydaelectronics.com/hardware/6-35mm-1-4-plugs-jacks/6-35mm-1-4-stereo-insulated-unswitched-socket-jack.html
i'm putting 6600uf caps in mine, they seem to run better with them. 2200 is ok, but quite a bit of ripple if ya run these hard. i tend to dime stuff, ....well.... i generally run the tone stack around 6, and the volume and gain dimed, anyways
however i marked them big caps is how they are on the board, but there's parts that just are omitted here and there.. not even mentioned on the board.
rob says i got that gain connection wrong, so i gotta check again WITH my beeper... but i think he's confusing the way the connection goes, cuz what you have now seems to match the drawing i had started and the board.
just to be sure, tho, i'm gonna beep it after dinner.
the jacks are like, identical to these:
https://www.taydaelectronics.com/hardware/6-35mm-1-4-plugs-jacks/6-35mm-1-4-stereo-insulated-unswitched-socket-jack.html