Quote from: markorock37 on December 30, 2011, 01:56:41 PMThat's what you should expect.
For whatever reason, pins 11 and 14 are at 24V now with the transistors removed.
Quote from: markorock37 on December 30, 2011, 01:56:41 PMOne of the new transistors is bad, and one of the originals was bad too.
There is the possibility that something in the circuit killed one of the new ones when you installed it. Did you find a short when you checked the transistors with an ohm meter? Check for shorts from the case of those output transistors to the chassis before you power up the amp. This is a good time to have one of those light bulb limiters, it will usually save the transistors if there is still a problem.
Nobody gave you an answer before, but the MJ15003 is a good substitute for 2N3055.