30% off all Honey Amp kits, check it out at https://store.ssguitar.com !
Quote from: joecool85 on November 12, 2022, 09:24:42 PMQuote from: Tassieviking on November 12, 2022, 09:04:06 AMTo me they look like clipping diodes, stick some sockets in the holes and then you can experiment with led's diodes etc.
If you get a row of SIP sockets you can break them off individually and solder them in.
They might also work as a signal limiter so the signal after this stage stays below a certain level, the led's would start conducting at a certain voltage and thus limit the voltage going to C9 and C10.
I'm going with clipping diodes. They were left out because the Pignose 30 is a bass amp and, generally speaking, people don't like distortion in their bass amps. You could throw the diodes in (though I do recommend using sockets as suggested above) and see if you like it.
Quote from: cdparady on November 18, 2022, 04:00:15 PMYah figured....
I have not gotten into it yet, guessing final blown but we will see.
Thank you !