Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - solidstatularbells

#1
I bought a used Gear4Music house brand 35W solid state amp. 2 inputs (High & Low), TMB EQ stack, Master Volume. The PCB has "BELCAT CORP. SED-03" printed on it.

I have no schematic for the circuit.

On the Low input, it works fine, but on the high input it distorts when I play hard. Particularly low notes.

What could be the fault? I am not an electronics expert, but I can certainly manage to replace a capacitor or resistor. I assume the High input only has a few extra components so that it will be easy to replace just those.

Of course, if anyone has the schematic on hand, that would be useful.