Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Tomsouthtrader

#1
Tubes and Hybrids / Re: VHT Classic 18 Preamp Modification
September 21, 2020, 11:39:17 AM
Hey,

So there is only 3 IC's on the board, and having followed the traces and double checking the pads.. It does infact just have 3 pins floating and the power pins going to the + and - 15v rails respectively.

But Having now having tried it without the capacitor before the input of the 12AX7 it sounds great!

My only questions now are..
How do I properly add a volume pot to the new input?
And is a capacitor before the valve needed?

Also many thanks for your reply's!!! <3)
#2
Tubes and Hybrids / Re: VHT Classic 18 Preamp Modification
September 21, 2020, 08:32:11 AM
From what I can tell the circuit only utilizes one side of at as 3 pins are just left floating..
And I figured the power for it on the schematic is 'IC1-2'??
#3
Tubes and Hybrids / VHT Classic 18 Preamp Modification
September 21, 2020, 08:14:49 AM
Hello There
I have been trying to modify my VHT Classic 18 (basically a cheep Chinese amp based loosely on a Marshall 18w circuit).
Essentially I am trying to completely bypass the awe full input gain stage that uses a TL072. And wire the guitar straight to the input of the first preamp tube..
I have found the schematic for the amp, and working from that I got the soldering iron out..
My aim was to completely remove the TL072 from the circuit and wire the input straight into the tube.
The schematic I have attached shows what I have done to the circuit.
The amp didn't blow up thankfully.
And it does make a sound... And The tone itself is not to bad (at least through the LO input).
However it now has a couple of issues  :-[

The input is now incredibly noisy. There is some sound even when the master is at minimum.
Also the treble control when turned all the way up makes make an awful noise (almost like some self oscillation). However I had never turned this all the way up before attempting this modification.

So I am asking for you knowlage and advice on how to fix my 'mod'  <3)

Link to the schematic and my 'MOD'..
https://drive.google.com/drive/folders/1Q-AdViC60HTd6p0KYzZEajgf1M5A8tYZ?usp=sharing