30% off all Honey Amp kits, check it out at https://store.ssguitar.com !
Quote from: g1 on May 27, 2024, 01:54:20 PMA dirty pot was my first thought too so I did give it quite a few twists and turns. No crackles, no pops, no jump scares.Quote from: Frank75 on May 27, 2024, 08:18:36 AMAs soon as I moved the volume pot I lost, say, 80% power.Have you cleaned the pots? If not, do so.
If you already have cleaned them, it sounds like the volume pot is defective or needs to be re-soldered.
Quote from: Frank75 on May 27, 2024, 08:18:36 AMAs soon as I moved the volume pot I lost, say, 80% power.Have you cleaned the pots? If not, do so.
Quote from: Mprall00 on January 29, 2019, 12:40:17 AMReplaced r17 with the 50k pot for gain. It sounds good now. Incredibly loud. It was oddly quiet stock for 30 watts
Quote from: DrGonz78 on May 15, 2024, 11:01:19 PMList voltage reading for Q8 & Q9 at all pin's connection points. Measure all power supplies. What are your -/+40v rails? -/+12v rails? Can you scope a signal through the unit and figure out where the signal goes bezerk?
Edit: If you scope the output is the fuzz actually crossover distortion?