Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - No6h

#1
oh. lol! I'll check the circuit later today, and then post some pictures. BEWARE, it is a very messy circuit board.
#2
I followed the signal path and got continuity between all the points on the board.
#3
After a big break, I have returned to my Noisy Cricket project. I have completely soldered the entire board, and am getting perfect continuity from the input jack to the speaker terminals. I still can not get any audio through when I touch the end of the guitar jack. What am I doing wrong... lol probably nooby but oh well xD
#4
Amplifier Discussion / Re: quick impedance question
November 12, 2015, 02:27:37 AM
Also would adding a stereo 3.5mm aux in after the preamp before the 386 change anything? So I could play backing tracks...
#5
Amplifier Discussion / Re: quick impedance question
October 28, 2015, 03:43:48 AM
I'm building a Noisy Cricket and am adding a headphone output (switched 6.35mm stereo jack), and am wondering how the impedance of my headphones 60Ω would affect the circuit? do I need to change anything or add a capacitor?
#6
Tubes and Hybrids / Re: Tino Zottola Tube amp book
October 02, 2015, 11:32:26 PM
thanks 8)
#7
Tubes and Hybrids / Re: Tino Zottola Tube amp book
October 01, 2015, 04:08:26 PM
No, just trying to find a legible Top Boost AC15 schematic from the 60's, I had heard that was a great source. Oh well.
#8
Tubes and Hybrids / Re: Tino Zottola Tube amp book
September 30, 2015, 08:07:29 PM
A lot of other websites are stating the same information. Have you read the book? is it useful? I'm trying to find a legible schematic for a Vox AC15 top boost, which is proving quite difficult, and I read somewhere this book has one in it.
#9
Tubes and Hybrids / Re: Tino Zottola Tube amp book
September 30, 2015, 03:05:31 AM
?
#10
Tubes and Hybrids / Tino Zottola Tube amp book
September 30, 2015, 12:00:39 AM
I discovered the book by Tino Zottola on tube amps, looked for it on Amazon, and discovered extremely ridiculous prices of over 2,700 USD? can anyone explain this? thanks  :cheesy:
#11
Just a question... where would be the best place to get a 2 layer 4x2" pcb in low volume? Thanks. I think I might learn to make layouts on simpler designs first.
#12
Hi. I have a friend who is a cabinetmaker and I just wanted to send him some plans...
#13
I'm interested in housing it in a Vox AC4TV style cabinet. ATM i'm trying to draw up some plans but no luck. Do any of you have experience in building cabs or any plans? I couldn't find any online.
#14
currently working on a cricket, should be done in a week or so
#15
How much of an increase in wattage will the TDA2003 make by replacing the 386?