Thanks. I was hopeful that these measurements were more reasonable. There is a spot on the circuit board that is fried. It is a very short run. The connection between the collectors of Q8 and Q9. I used a piece of wire to bridge that gap. The first measurements when the supplies were 1v, and more important stuck + were taken after I removed Q8 and Q9. When I removed them I also removed the wire that bridged the gap. Another thing I learned along the way, if something changes and doesn't make sense, look at the work you did. Look at the schematic and imagine the entire line that connects the collectors of Q8 and Q9 erased. Well that is what my board looks like. I have placed a piece of wire there to bridge the gap, and then took new measurements. I will try to put up a few pictures. My camera is eating batteries.