Solid State Guitar Amp Forum | DIY Guitar Amplifiers
Solid State Amplifiers => Schematics and Layouts => Topic started by: gearhead63 on June 21, 2014, 10:29:22 PM
Took me a while but I found this so I could fix this mixer.
Adobe Reader XI gave me an error and wouldn't open the file.
No problems in Nuance PDF reader.
The output stage is ... um ... a bit full-blooded. ???
I just downloaded and opened it with no problem!
Nevermind! :loco I see it now that I'm logged in. Thanks!! This will help a lot!
I have blown outputs on this PA System and a popped run. Really would like to get a schematic and go through this thing before putting back in action. I don't see a link for this manual, can anyone help me out?
Thanks,
Rac
I NEED A PICTURE OF THE WIRING ON THE INSIDE OF A FENDER SR 6300P POWERED MIXER DESPERATELY! SOMEONE UN-DONE ALL THE WIRES IN MINE!!! :-\ PLEASE HELP! THEANK YOU!
https://www.ssguitar.com/index.php?action=dlattach;topic=3501.0;attach=4607
All the information that you need is on the schematic.
Great Schematic just what I was looking for, have a bad amplifier with burn out R33 resistor reading over 600 Ohms and it should be 10 ohm 2Watts. Also burn out power transistors 2SC3281 (Q4,Q5,Q6 )and 2SA1302 (Q7,Q8,Q9).