I am still curious, like Enzo was, about what make and model amp we are looking at. Perhaps there is a schematic to look at to figure out what could have burnt up that resistor in the first place.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.Show posts Menu
Quote from: pinkjimiphoton on August 31, 2021, 01:02:18 PM
since i can't seem to get a reading for any voltages at pins 4 and 8, and no output after the 1458, should i assume the opamp is toast? a shorted opamp would make it so i get no voltage readings anywhere, wouldn't it?
Quote from: flester on April 28, 2021, 09:21:37 AM
Where would the low ass filter go?
Quote from: Pepe on April 11, 2021, 12:49:21 PMI tried the cable jump method and it seems to work okay, channel a is good and channel b seems a little off but is doable. What causes this issue?
Quote from: Stefan on February 12, 2021, 03:56:30 AM
2. Reverb cables to the reverb box, does it matter which they they go on?
Are the red and black cables on the reverb box (RCA connectors) reversible? That is, does the circuitry mind which way they are plugged in? Tried both ways and it does not seem to make any difference. (I think the term for this is 'polarity'.) Just want to be sure.