Hi Phatt
Thanks for the tips!
I found the points you listed on the PCB however I have never done this type of troubleshooting before so I have a few basic/stupid questions:
-What do you mean by "either side of common"? I can't find a GNDA label on the PCB (I might just not have looked hard enough xP ) Im guessing GNDA is a ground and that I should measure the voltage between the TPx points and ground?
-When I do these measures should the amp be powered or shut off?
again thanks everyone for all the great input!
Thanks for the tips!
I found the points you listed on the PCB however I have never done this type of troubleshooting before so I have a few basic/stupid questions:
-What do you mean by "either side of common"? I can't find a GNDA label on the PCB (I might just not have looked hard enough xP ) Im guessing GNDA is a ground and that I should measure the voltage between the TPx points and ground?
-When I do these measures should the amp be powered or shut off?
again thanks everyone for all the great input!