Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Jazz P Bass

I found 2 Ward Airline SS schematics in my files.
Here they are.
Schematics and Layouts / Re: Randall RG100 G3 Plus
December 02, 2021, 01:13:42 AM
Attached is what I have for the Randall G3 schematics.
From the Web: "Made in the sixties for film editing, this little squawk box amp is all kinds of fuzzy fun. You can play straight into the amp through its rattly tiny speaker, or use the headphone jack to run it into another amp ..."
Sounds like a fun project.
The real issues will be the cabinet & the recharge circuit.

Alesis has a 25 w/ 50 w peak amp for under 200 US.
The Newcomer's Forum / Re: Warwick Xtreme 10.1
September 27, 2021, 12:20:57 PM
Here is the schematic if thqt helps.
Amplifier Discussion / Re: Fender M80 Issues
September 27, 2021, 12:20:51 AM
More likely than not there was a zener diode failure.
Cr 25 or CR26 on this drawing.
The Newcomer's Forum / Re: Hello
September 15, 2021, 11:25:45 AM
Welcome to the sight.
It sounds like you are on a roll!
Amplifier Discussion / Re: Fender London Reverb
September 09, 2021, 12:22:57 AM
What does the supply read for the power amp stage?
+33Vdc & -33Vdc is stated.

The 15 Vdc supply is for the opamps.
A 3 volt drop will not hurt.
As long as they are both the same. (+ & -)

The 18 Vdc supply is for the reverb & effects.
Again. No biggy as long as they are both the same.

Have you checked for Vac ripple?

The Newcomer's Forum / Re: Greetings from a new member
September 04, 2021, 01:34:16 AM
Hello, Andre.
Welcome to the Forum.
Ohms Law
375W /120V = 3.12Amps

What you should look for is a cord that is the proper length for how you plan to use the amp.

At home a 5 or 6 ft cord will be fine.

On a stage you may want a 10 footer.
I am simply going by Roland's recommended values.
Leaving out the ground resistor defeats the divider circuit.

Play with the values if you like.
"What would happen if I leave it out?"

You will not have a proper 'voltage divider' circuit.
Honey Amp / Re: Thoughts on my new Honey Amp
July 28, 2021, 11:45:33 AM
" No power switch, but I can understand the omission, since this is supposed to be highly customizable. I have to pop the battery connectors to power down, but my enclosure choice makes that easy enough"

You could try a 3 prong switching jack that disconnects the battery ground when no cord is inserted.

Like pedals use.
The Line Out circuit uses 2 47K and 1 100ohm resistors for the summing network.
You can disconnect R155 and add a 100 ohm resistor to ground to get a separate feed.
The Newcomer's Forum / Re: Just joined...
July 07, 2021, 12:44:00 AM
Welcome to the place.