Solid State Guitar Amp Forum | DIY Guitar Amplifiers

Solid State Amplifiers => Amplifier Discussion => Topic started by: Bill Moore on September 10, 2015, 01:25:36 PM

Title: Peavey Reverb Cable.
Post by: Bill Moore on September 10, 2015, 01:25:36 PM
Thought I would share this. Some Peavey amplifiers have a 5 pin Molex connector that attaches to the circuit board to connect the reverb tank. I had no luck finding one anywhere, but found that 2 2 pin connectors will work.
Molex Recepticle  03-09-1027
Molex Terminal     02-09-1119




Title: Re: Peavey Reverb Cable.
Post by: J M Fahey on September 22, 2015, 07:34:53 PM
Thanks  :dbtu: