Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - bsantos

#1
Amplifier Discussion / Re: Rocktron Rampage R80
June 25, 2020, 08:33:55 AM
Thanks for the suggestions!
Regards
#2
Amplifier Discussion / Re: Rocktron Rampage R80
June 23, 2020, 05:46:43 PM
Hi again,
So, I tried the cord between the send and the return jacks and it worked! Thanks for the tip!

While this is certainly a good workaround, how would suggest to fix this? This may.simply be related with some dirt in the connector. So, replacing it may be a bit of an overkill. Any suggestions on how to clean it up?

Since I have the amp opened and the PCB's are exposed, would you suggest any procedure to avoid other issues, like cleaning it up?

Thanks and regards,
Bruno
#3
Amplifier Discussion / Re: Rocktron Rampage R80
June 22, 2020, 05:28:35 PM
Hi there!

Thanks, will try the patch cord tomorrow.
I did contact Rocktron support but I have no reply so far.

Thanks and regards,
Bruno
#4
Hi @strombringer

Did you ever get to fix the issue?
I have exactly the same problem on my R80.

Also, did you find the schematics?

Thanks and regards,
Bruno
#5
Amplifier Discussion / Re: Rocktron Rampage R80
June 22, 2020, 07:47:01 AM
Hi @jamie5152,

Were you able to get the schematics? Could you please post it here?

I have this very same amp, for a long time, since 1999, I think. Eventually it started to show this problem: it randomly shuts down the input signal and there's  no sound out of it. After some time it recovers. Also, if I turn it off and on again it stays fine for a while. It has been in a shelf for years and now I am trying to fix it. But without the schematic it's tough.

Would really appreciate if you could send me the schematics.

Thanks and regards,
Bruno