Solid State Guitar Amp Forum | DIY Guitar Amplifiers
Solid State Amplifiers => Amplifier Discussion => Topic started by: ddpiax7 on February 22, 2021, 06:36:23 PM
Hello all,
Working on a Pignose 30/60, which doesn't have any bias or offset pots, and I just replaced the drivers and output transistors. The amp sounds great, but my background is predominately vacuum tubes so I'm not even sure whether this even matters?
If I can figure out how, I'll post a schematic. The amp is from 1979 but the schematic is on the web.
Thanks in advance,
Pete
I just started a new post about this same amp and included a schematic in my post if that is of any help.
Iit works and sounds great? And there ar no adjustments anyway? Then stop fixing it and enjoy the amp.