Welcome to Solid State Guitar Amp Forum | DIY Guitar Amplifiers. Please login or sign up.

June 28, 2022, 02:45:31 PM

Login with username, password and session length

 

Testing Resistors

Started by memoryman, November 17, 2015, 09:49:43 PM

Previous topic - Next topic

memoryman

I just tested a 68K 10% and it tested at 76.7K ohms is it too far out of spec? How do I determine this for myself?

Roly

68k + 10%

68k + 6.8k = 74.8k

So 76.7k may be out of spec if you are using an expensive and accurate ohmmeter, however it is unlikely that it is, and even if so that it would seriously effect the circuit - there are simply too few places where such a difference wouldn't be within the tolerance of the circuit (or they would have originally fitted a 5% or 1% component, and they don't).

Measure a known new one(s) of any values(s) and see if they all come up reading a bit high.  If so, relax.  If not we are talking a fraction of a cent - replace it.

Audio circuits just ain't that critical, +/-20% or more would still cut it fine.    :tu:
If you say theory and practice don't agree you haven't applied enough theory.

memoryman

Thank you Roly its always good to hear from you.

Enzo

And was the resistor already soldered into a circuit?  If so, make sure to measure, then reverse the meter leads and remeasure.  That will expose any tiny residual voltages confusing the meter.

memoryman

Good idea Enzo I will do that, thanks :)