Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - ksor

#1
Quote from: Roly on March 31, 2013, 03:56:15 AM
Welcome Ksor.

Looking at the circuit of the Fender Blues Deluxe the Power Amp In appears to be quite sensitive, only about 35mV for full output, in fact this should be similar to the normal main inputs.

If you don't have a users manual for the Korg AX1000G then you can download it from www.korg.co.uk/downloads/ax1000g/AX1000G_OM.pdf.  If you haven't, I suggest you download and read.

You could make up a simple 10:1 or 100:1 output attenuator lead with a couple of resistors in one of the plugs, but have you tried setting the Master Level to a low value?
Thx to all of you !

I think I'll try the "lowering-master-method" in the first place  :)
#2
>> Phil
Just turn the master Downon the AX1000G and then through

1) the normal INPUT

OR

2) the effect-loop on behind the Fender

what is "best practice" ?


#3
How should I connect this guitar processor RomeWorks AX1000G to the Fender amp - if I just put it "in front" there is a lot of noise - if I use the "effect link" on the back of the Fender there is a LOT OF FEEDBACK howling !  :duh :duh :duh

how should it be done ?