Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - a.narloch

#1
Hi everyone, newbie here  :)

I got few questions about Ampeg SVT preamp on FETs.
I try to build cheaper version of Ampeg tube amp so I decide to use fets in preamp and mosfets in poweramp.
Poweramp is finish and it works so now i must build the preamp :)
Today I draw schematics, i based on schematics:

Ampeg PortaFlex SB-12 draw by Joe Piazza:  http://1.1.1.2/bmi/www.drtube.com/img/icon-gif.gif
Ampeg SVT draw by Joe Piazza:              http://1.1.1.2/bmi/www.drtube.com/img/icon-gif.gif

and articles:

http://www.runoffgroove.com/fetzervalve.html
http://www.runoffgroove.com/flipster.html

I compare schematics of Ampeg PortaFlex SB-12 and Flipster and i found analogy and I use it too draw schematic of SVT.
EQ in both models (svt & portaflex) is the same so I copy eq from Flipster and I use it in my version of SVT.
In orginal SVT they use a 12dw7 tube. I read that it is a dual triode with one half from 12ax7 and second half from 12au7.
So I use J201 and MPF102 transistors, J201 I put in place of 12ax7 becouse it has a more gain
and MPF102 a put in place of 12au7 becouse it has less gain :) In nearest future I wanna project PCB but before I do it i wanna now that schematic is correct. I be very thankful if somebody check the schematic.

http://obrazki.elektroda.net/73_1243549637.jpg -> my schematic

best regards
a.narloch

P.S sorry if my english sucks, I hope You understand me :) and I understand You :P