Solid State Guitar Amp Forum | DIY Guitar Amplifiers
Solid State Amplifiers => The Newcomer's Forum => Topic started by: benzer on September 14, 2007, 01:03:27 PM
Howdy folks, im new to this forum so i gorra say howdy to everyone.
my name is Ben and im an electronics engineering student.
pretty much interested lately in audio .
i have very much information about electronics and pretty good in theory but i havnt built my first amp yet.
it is time to do so,,i have designed the amp (20 watts) using proteus and matlab to design my filter and tone control.
i would like to anybody to see the schematic and give me advice on wether its gonna work or not ,,or if there are some mistakes .
if anyone is willing let me know.
general info about the amp : >>
im using the compound configuration for my power transistors
they are the BD139-BD140 OUTPUTS TO BD539-BD540.
outputs +-12 volts into 8 ohms speaker
i used a first degree band pass filter 20-20000hz
and the general filter configuration for the bass-treble control with the variable cap and a pot.
let me know if anybody is interested so we can talk this amp up
thankya'll already
BeN
Quote from: benzer on September 14, 2007, 01:03:27 PM
let me know if anybody is interested so we can talk this amp up
thankya'll already
BeN
I'm sure if you post the schematic you will get plenty of conversation about this amp. I know I'm interested.
alright im gonna post the schematic in the schematics section
and provide some info about the amp ..