I think your meter is trying to average the AC voltage on the two inner pins.
Try with the meter set to to Volts AC.

Ok guys sorry for the bo bo 

Anyhow removed the old one (no easy task) and got a new one in

You cannot view this attachment.

Seems all is good when measuring the (+) pin and two middle pins (~)

(+) pin reads about 40v DC (have no idea what it is supposed to be


You cannot view this attachment.

But when I read the middle pins I get like 16v ac but what the heck I get 20v DC

You cannot view this attachment.

I think I'll call it a night

 

Yes sir thanks I was able to find some old pics of the original part

You cannot view this attachment.

You cannot view this attachment.

 

The rectifier is installed backwards.

Yes sir appears to go to

-negative terminal of capacitor

You cannot view this attachment.

-and the emitter of the tip31a on the right

You cannot view this attachment.

and a resistor

Follow the trace from the bridge + lead to filter cap.  Is it going to + or - end of cap?

Quote from: markorock37 on April 13, 2024, 02:57:58 PMI don't see 2SA872 on Mouser, is KSA992 a good sub?

Yes, those should work.

Meanwhile... experienced my first Chernobyl.

So this metronome I had removed the bridge rectifier a while back and it tested good...oh well

Put a new one in today.... thought it would be fun to hook my meter to the leads before I clipped em and read ac and DC on the different leads.

So I solder it in...crudely soldered the transformer wires back making sure I put the right ones in order.  Plug it in...I'm gathering up my meter and test leads and I hear woosh and see lots of smoke

You cannot view this attachment.

And liquid 

Later I was outside and thinking did I put it in backwards or something...or leave a solder bridge?  But looks like the orientation is correct and the solder reasonable (these pics are post meltdown)

You cannot view this attachment.

You cannot view this attachment.

Im beyond hoping this thing will be fixed but I did want to replace that part.

Meanwhile I put it on my ugly dbt after the fact yes it was glowing.

 

I don't see 2SA872 on Mouser, is KSA992 a good sub?

Thanks G1 it's a gorgeous day today with plenty of sunshine so I'm actually fixing to take some good pics of this scope so I can put it on the auction site.  Hope is waning that the ever so coveted green trace will ever appear.
I'm happy that it's been a great learning tool but at this point I don't even know if the CRT is any good. When I first got it there was a slight glow at the small end and it gets dimmer and dimmer.
Also there are a bunch of rusty trim pots then another board has an open somewhere (at the minimum).
A 68v zener is cheap though I might need to see that localized issue settled.
Also I really like that arrow pointing at that node and a diagram of a square wave.
Would be cool to see if that is there with my other scope.