30% off all Honey Amp kits, check it out at https://store.ssguitar.com !
Started by joecool85, December 02, 2010, 01:52:47 PM
Quote from: phatt on January 11, 2011, 10:00:57 AMYep I'd say so,M is the voltage rating of the device.Can't remember them all off hand but I think *J* means a 100volt rating.Some makers use different codes but after a while you catch on to the tricks.Phil.
Quote from: J M Fahey on January 11, 2011, 04:03:04 PM Been watching Australian floods on TVWOW !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!Becoming worried about Phatt and a couple other Aussies which frequent this virtual smoky joint.All right pals ?We want proof of life !!!Post something or at least let go some bubbles, so we can see them in the surface.Just in case, I'm getting my Scuba equipment ready.Good luck. :tu:
Quote from: phatt on January 12, 2011, 11:05:16 AMHaving witnessed the 74 floods,,, I make a point of living on top of hills rather than low lying areas. 8|Phil.
Quote from: phatt on January 15, 2011, 09:44:49 AMHi Joe, A suggestion if I may.As a stand alone unit it would be wise to hang a buffer at the end of this.It's a low imp tone stack which are not as lossy as high impeadance TStacks but just the same the circuit is some what dependant on what it plugs into.A buffer will fix any interface issues that may arise.There are a few well known pedals that do as you have done but it's not good design practise. Cheers Phil.
Quote from: joecool85 on January 15, 2011, 04:56:49 PMOk, what about the resistor and cap that teemu had on the end of the circuit that I didn't add in?
Quote from: joecool85 on January 15, 2011, 04:56:49 PMThe schematic had a resistor inline as well as one to ground and a cap to ground originally right before going into the poweramp circuit - should I put these in?