Tubes do not warm up. No sound out of amp.

[J M Fahey]

I did check them

And what was the result? You tell us half the story :lmao:
Seriously, do as suggested above, with your meter on 20VAC check if you have 6.3VAC from pins 4+5 (they are usually united) to pin 9, and probably 12V DC from pins 4 to 5 in the first triodes.
Usual problem with *all* Bugeras is poor internal connectors , best is to pull them and solder wires straight to PCB pads.

[JacksenC]

I did check them

And what was the result? You tell us half the story :lmao:
Seriously, do as suggested above, with your meter on 20VAC check if you have 6.3VAC from pins 4+5 (they are usually united) to pin 9, and probably 12V DC from pins 4 to 5 in the first triodes.
Usual problem with *all* Bugeras is poor internal connectors , best is to pull them and solder wires straight to PCB pads.

:lmao:
I'm sorry
I was busy  :mobile

oh it's pins 4+5..my bad
Yesterday I checked the 2 + 7 pin from power tube slot
the needle from my multitester didn't move

ok then i'll check them tonight