30% off all Honey Amp kits, check it out at https://store.ssguitar.com !
Started by luke gibson, August 26, 2023, 05:30:26 PM
Quote from: Tassieviking on August 27, 2023, 01:07:16 PMI have never seen one of these amps, but I have looked at the schematic a few times and wondered if I should try making one for the fun off it.The original schematic is fairly hard to read, but I gave it a go and re-drew it.I have most likely made some mistakes,and I left some values off because I can not read them if wanted to.When you replace the capacitors you only need to replace the electrolytic ones, they look like little cans.They should be easy to check by just lifting the lid of the amp and having a look, please do not go by what I think the schematic says or even the original schematic as Marshall sometimes changed components to make the amps more reliable.These changes did not always make it onto the schematic for years till they made a new revision of the schematic. If you find any components I have marked wrong then please let me know and I will upgrade the schematic,CheersMick
Quote from: phatt on August 31, 2023, 06:58:21 AMIs there any particular reason why you want to replace the Capacitors?If the Amp works fine don't mess with it.Phil.
Quote from: phatt on September 03, 2023, 06:45:16 AMYep this confused me years back, 2u2 would be 2.2uFI did read somewhere that the point can be easy missed in drawings and after many photo copies and creases in the paper it may look like 22uF. Same goes for R's 2k2 = 2.2k.HTHelps, Phil.